The product is on the Injection Mold Design.Plastic mold

  If the plastic parts are very simple, just design them just fine. Then consider the cooling water position, the position of the top rod, the position of the fixing screw, the position of the reset rod Finally, the size of the formwork and the thickness of the formwork are determined. However, the curriculum design is not too complicated, and all the steps are all right. In the case of the special case, the formwork is smaller. Look at the book step by step. In addition, we must design the core, the launch mechanism or something. Qi Weidong.) Supplement: There are mainly the choice of parting surface, the choice of gate location, etc. This will result in large injection cost and reduced profit for the manufacturer. Analyze the material port, first select the feed side. Beijing:

Chemical Industry Press 3. . The position of the runner, the runner gate, the position of the jack, the position of the cooling water, the size of the front and rear molds, and finally the size of the mold base. Beijing: Mechanical Industry Press. Guangzhou: South China University of Technology Press, 'Plastic Mold Technical Manual' Editorial Board, Plastic Mold Technical Manual. Concise Plastic Mold Design Handbook.

The product is on the Injection Mold Design.Plastic mold structure analysisTo analyze the structure of plastic molds, we must first understand whether the products have the conditions for mold opening, whether there are drafting, excessive wall thickness, shrinkage deformation, undercut and other factors affecting the mold, and understand the shrinkage rate and fluidity of the product materials.  high speed injection molding These are necessary. Practical tutorial for injection mold design. I have set up to do plastic mold design, recommend a few books for you, certainly useful: Wang Shuxun, Zhu Yalin, Mei Wei, Long Guoliang. After the front and rear molds are determined, the position of the parting surface of the product is determined.. After the position of the mold gate and the runner, and the relevant information about the product structure and materials, the next step is to determine the front and back molds of the product. Zhang Wei Including. Beijing: Beijing Institute of Technology. (I think: first choose the mold material according to the quantity of the product. Then consider the number of molds